As far as I know, all electronics have to go through FCC testing to make sure they don't interfere with emergency broadcasts or whatnot. Take a look at the back of your iPod- there's even an FCC logo on there.
There may be several reasons why the cameras needed FCC approval. If the camera has a microprocessor that operates above 1.705 MHz or connects to one that does. I'm not sure if these cameras have microprocessors in them, they probably do, but I know they do connect to the USB port of any computer. The cable can act as an antenna and either receive or transmit signals from or to the computer. As a matter of fact, the one I have has a ferrite bead molded onto the cable about an inch from the camera end suggesting the noise comes from the camera. Another requirement is if a digital device consumes more than 6 nanowatts and I'm sure this does, even though it runs off of two AA batteries. You would be surprised as to how many different types of devices have to be approved by the FCC.
Reader Comments (Page 1 of 1)
chuck @ Dec 24th 2006 2:36PM
As far as I know, all electronics have to go through FCC testing to make sure they don't interfere with emergency broadcasts or whatnot. Take a look at the back of your iPod- there's even an FCC logo on there.
Robert @ May 8th 2007 8:34PM
There may be several reasons why the cameras needed FCC approval. If the camera has a microprocessor that operates above 1.705 MHz or connects to one that does. I'm not sure if these cameras have microprocessors in them, they probably do, but I know they do connect to the USB port of any computer. The cable can act as an antenna and either receive or transmit signals from or to the computer. As a matter of fact, the one I have has a ferrite bead molded onto the cable about an inch from the camera end suggesting the noise comes from the camera. Another requirement is if a digital device consumes more than 6 nanowatts and I'm sure this does, even though it runs off of two AA batteries. You would be surprised as to how many different types of devices have to be approved by the FCC.